Sometimes a little mistake in your printed circuit board will cost you several hours even more to find out. To debug your circuit effectively, here’s the method we recommend to you. Several steps are listed as follows:
-Print (or draw) your schematic diagram on a piece of paper
-Looks at the schematic diagram first, and then look at your circuit
-You can start at the positive supply, and make sure what it should be connected to
-You check your circuit and mark yes as a record on a paper for everything that you have confirmed is there
-Check one by one in a correct sequence, and do this until all the connections are checked
It may take you a little extra time, but it is really helpful, and save more time for you to some extent.
Learn more, pls visit www.epcb.com
没有评论:
发表评论